Thanks guys,I hadn't even looked in the adv.h tab.I tried printing a test cube yesterday,but still had some extruder issues.
The homing signal pointed out that the endstops don't work reliably,because both x and y axes overran the switches,e.g., the motors kept turning,with the belts rattling over the pulleys for a bit.
Perhaps I can cure this in the offsets configuration?
I seem to have a dodgy USB port on the laptop now,sometimes it doesn't want to connect.
Is it ok to run the ramps USB cable through a hub?
The homing signal pointed out that the endstops don't work reliably,because both x and y axes overran the switches,e.g., the motors kept turning,with the belts rattling over the pulleys for a bit.
Perhaps I can cure this in the offsets configuration?
I seem to have a dodgy USB port on the laptop now,sometimes it doesn't want to connect.
Is it ok to run the ramps USB cable through a hub?